| Series Name: | TACT SWITCH |
| Part Number: | TD-1124-NC |
| Contact Rating: | DC 12V 50mA |
| Actuator Height: | 2.5mm |
| Dimensions: | 6 mm x 3.9 mm |
| Operating Force: | 160 gf ± 50gf / 250gf ± 80gf |
| Operating Temperature: | -20°C to +70°C |
| Electrical Life: | 100,000 cycles |
Contact resistance
100 mΩ max.
Insulation resistance
100 MΩ min.
Voltage proof
An AC voltage of 250 V and an induced current of 1 mA shall be applied between terminals, and between terminals and frame, for one minute.
Terminal strength
A static force of 300 g shall be applied in one direction to the tip of the terminal for 1 minute.
Operating force
160gf / 250gf
Soldering test
The tips of the terminals shall be dipped 2 mm into a solder bath at a temperature of 235±5℃ for 3 seconds.
Soldering resistant test
The manual soldering temperature shall be 350±5℃ for a soldering time of 3±0.5 seconds; however, excessive pressure shall not be applied to the terminal.
Reflow soldering heat test
Preheat: The temperature of the copper foil surface should reach 180℃ within 120 seconds. Then, load the PCB into the equipment.
Moisture resistant test
40±2℃ 90-95% RH for 96 hours. Test after keeping in normal condition for 30 minutes.
Cold resistant test
-40±3℃ for 96 hours. Test after keeping under normal conditions for 30 minutes.
Heat resistant test
80±2℃ for 96 hours. Test after keeping under normal conditions for 30 minutes.
Wave soldering test
Under Sealing Pack
Under sealing pack condition, stored temperature doesn't exceed 30℃ and relative humidity is 75% RH. In the environment of no sunshine direct and no corrosive gas, the stored time ought to be three months but within six months at most.
Without Sealing Pack
Without sealing pack condition, stored temperature doesn't exceed 30℃ and relative humidity is 75% RH. In the environment of no sunshine direct and no corrosive gas, the stored time shouldn't exceed 168H. Don't excessive overlap or overstocking when keeping these goods, in case of damage.
Submit your required pin configurations, target quantities, or CAD requests. Our application engineers will confirm lead times and pricing within 24 hours.
